LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2017 >> Traverse LS Base >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 3.6L (LLT) - Repair Instructions >> Repair Instructions >> Knock Sensor Replacement - Bank 2 >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Left Knock Sensort - Bank 2
    GM860802Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  1. Position the knock sensor and tighten the knock sensor bolt.

    Tighten 

    Tighten the bolt to 23 N.m (17 lb ft).

    2. Fig 2: Engine Wiring Harness Electrical Connectort - Bank 2
    GM1860484Courtesy of GENERAL MOTORS COMPANY
  2. Connect the engine wiring harness electrical connector (2) to the bank 2 knock sensor (3).
  3. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Install Catalytic Converter Replacement - Left Side
  5. Install a NEW engine oil filter. Refer to Engine Oil and Oil Filter Replacement .
  6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals