Unsuccessful Programming Recovery

In the event of an interrupted or unsuccessful programming event, perform the following steps:

1. Ignition ON. Ensure the K109 Frontview Camera Module, DLC and programming tool connections are secure and the SPS software is up to date.
2. Verify the K109 Frontview Camera Module can be reprogrammed.
   • If the K109 Frontview Camera Module cannot be reprogrammed 
   1. Ignition OFF for 1 min, ignition ON.
   2. Verify the K109 Frontview Camera Module can be reprogrammed.
      • If the K109 Frontview Camera Module cannot be reprogrammed, replace the K109 Frontview Camera Module.
      • If the K109 Frontview Camera Module can be reprogrammed.
   3. All OK.
   • If the K109 Frontview Camera Module can be reprogrammed 
3. All OK.