Using Scan Tool
NOTE:
Before proceeding with the steps below, ensure that no other sensor learn procedure is being performed simultaneously and that no tire pressures are being adjusted on another TPM equipped vehicle within close proximity.
- Connect scan tool. Turn ignition switch to RUN position. Apply parking brake.
- Using scan tool, select "SPECIAL FUNCTIONS".
- Select "SENSOR LEARN MODE ENABLE", and press ENTER key.
- Press ON soft key. A double horn chirp will sound, indicating the learn mode has been enabled.NOTE: The left front turn signal will also illuminate to indicate the learn mode has been enabled.
- Activate the sensors by one of the following methods:
Increase/Decrease Method: Starting with left front tire, increase or decrease the pressure for 8-10 seconds, then wait for a horn chirp sounds. The horn chirp may occur before the 8-10 second pressure increase/decrease time period has been reached, or up to 30 seconds after the 8-10 second pressure increase/decrease time period has been reached.
Sensor Activation Tool Method: Starting with the left front tire, hold the scan tool against the tire wall aiming upward with the antenna. Press the activate button and wait for a horn chirp. After the horn has chirped, the turn signal will illuminate indicating the next location to be learned.
- After horn chirp has sounded, repeat procedure for the next 3 sensors in the following order: right front, right rear, left rear.
- After left rear sensor has been learned, a double horn chirp will sound, indicating all 4 sensor IDs have been learned. Turn ignition switch to OFF position. Adjust all tire pressures to specification.