Installation Procedure
- Transfer the window regulator motor (5) to the regulator. Refer to Door Window Regulator Motor Replacement .
Install the window regulator and motor in the door.
- Install the upper and lower bolts (1, 3).
Tighten
Tighten bolts to 10 N.m (88 lb in).
- Install the nut (2).
Tighten
Tighten nut to 9 N.m (80 lb in).
- Remove the window support and lower the window to the window guide on the regulator.
- Connect the electrical connector to the regulator motor.
- Install the window to regulator bolts. Refer to Rear Side Door Window Replacement .
- Operate the window upward to the full up position, ensuring the window remains in the run channels.
- Install the energy absorber retainers and energy absorber to the door.
- Install the covers that conceal the regulator bolt holes.
- Inspect the window regulator for proper operation.
- Install the water deflector. Refer to Rear Side Door Water Deflector Replacement .
- Install the door trim panel. Refer to Rear Side Door Trim Panel Replacement (Enclave)Rear Side Door Trim Panel Replacement (Acadia or Traverse) .
CAUTION:
Refer to Fastener Caution .