LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2017 >> Volt LT >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Shift Lock Control System >> Diagnostic Information and Procedures >> Transmission Control Lever Malfunction >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Vehicle OFF, disconnect the X1 harness connector at the K9 Body Control Module, Vehicle in Service Mode.
  2. Verify a test lamp illuminates between the B+ circuit terminal 4 and ground.
    • If the test lamp does not illuminate and the circuit fuse is good 
    1. Vehicle OFF.
    2. Test for less than 2 Ω in the B+ circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, verify the fuse is not open and there is voltage at the fuse.
    • If the test lamp does not illuminate and the circuit fuse is open 
    1. Vehicle OFF.
    2. Test for infinite resistance between the B+ circuit and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • If infinite resistance
    3. Disconnect the harness connector at the S3 Transmission Shift Lever.
    4. Test for infinite resistance between the control circuit terminal 4 and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • If infinite resistance, replace the S3 Transmission Shift Lever.
    • If the test lamp illuminates 
  3. Vehicle OFF and all vehicle systems OFF, connect the X1 harness connector at the K9 Body Control Module. Disconnect the harness connector at the S3 Transmission Shift Lever. It may take up to 2 minutes for all vehicle systems to power down.
  4. Test for less than 10 Ω between the ground circuit terminal 2 and ground.
    • If 10 Ω or greater 
    1. Vehicle OFF.
    2. Test for less than 2 Ω in the ground circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, repair the open/high resistance in the ground connection.
    • If less than 10 Ω 
  5. Vehicle in Service Mode, connect a test lamp between the control circuit terminal 4 and the ground circuit terminal 2.
  6. Verify the test lamp turns ON and OFF when commanding the Brake Transmission Shift Interlock Solenoid Actuator ON and OFF with a scan tool.
    • If the test lamp is always OFF 
    1. Vehicle OFF, remove the test lamp, disconnect the X7 harness connector at the K9 Body Control Module.
    2. Test for less than 2 Ω in the control circuit end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit
      • If less than 2 Ω, replace the K9 Body Control Module.
    • If the test lamp is always ON 
    1. Vehicle OFF, remove the test lamp, disconnect the X7 harness connector at the K9 Body Control Module, Vehicle in Service Mode.
    2. Test for less than 1 V between the control circuit and ground.
      • If 1 V or greater, repair the short to voltage on the circuit.
      • If less than 1 V, replace the K9 Body Control Module.
    • If the test lamp turns ON and OFF 
  7. Test or replace the S3 Transmission Shift Lever.
scientia non olet · About LEMON Manuals