Circuit/System Verification
- Engine running.
- Verify the scan tool Crankshaft Position Active Counter parameter increments.
- If the counter does not increment
Refer to Circuit/System Testing.
- Go to next step: If the counter increments
- If the counter does not increment
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTC sets
Refer to Circuit/System Testing.
- Go to next step: If the DTC does not set
- If the DTC sets
- All OK.