LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2018 >> Spark LS, Standard Trans >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Electronic Power Steering Motor Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. GM4024320Courtesy of GENERAL MOTORS COMPANY

    Install the electronic power steering motor control module (2) to the electronic power steering motor control module bracket (3).

    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the electronic power steering motor control module mounting bolts (1) and tighten to 3 N.m (27 lb in).
  3. Install the electronic power steering motor control module and bracket assembly to the vehicle.
  4. GM4024319Courtesy of GENERAL MOTORS COMPANY

    Install the electronic power steering motor control module bracket bolts (1) and tighten to 18 N.m (13 lb ft).

  5. Connect the electrical connector to the electronic power steering motor control module.
  6. Install the I/P knee bolster. Refer to Instrument Panel Knee Bolster Replacement .
  7. Install the steering column lower trim cover. Refer to Steering Column Lower Trim Cover Replacement .
  8. Install the steering column upper trim cover. Refer to Steering Column Upper Trim Cover Replacement .
  9. Program the electronic power steering control module. Refer to Control Module References .
  10. Calibrate the steering angle sensor. Refer to Steering Wheel Angle Sensor Centering .
scientia non olet · About LEMON Manuals