Reprogram Control Module
WARNING: This page is about a different car, the 2019 Chevrolet Traverse. However, it is still accessible from the selected car via links, so may be relevant.
Do not reprogram the parking assist control module, unless directed by a service procedure, or a service bulletin.
To reprogram an existing control module, perform the following procedure:
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, under Select Controller, select K182 Parking Assist Control Module.
- On the SPS Supported Controllers screen, under Select Function/Sequence, select Programming and follow on screen instructions.
- At the end of programming, choose the "Clear All DTCs" function on the SPS screen.