Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

Steering Gear Boot Inner Clamp (3) @ Steering Gear Boot (2) - Loosely install

Install a NEW clamp.
Apply the lubricant from the service kit to the steering linkage inner tie rod and to the steering gear boot.
Steering Gear Boot (2) - Install
Courtesy of GENERAL MOTORS COMPANY

Use the CH - 804 tensioner to tighten the steering gear boot inner clamp (1).
Courtesy of GENERAL MOTORS COMPANY

Steering Gear Boot Outer Clamp (2) - Install
Steering Linkage Inner Tie Rod Nut (1) - Install
Steering Linkage Outer Tie Rod - Install - Steering Linkage Outer Tie Rod Replacement
Measure and adjust the front toe. Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment