Unsuccessful Programming Recovery

If programming a control module is not successful, perform the following procedure:

1. Ignition ON. Ensure the control module, DLC and programming tool connections are secure and the SPS software is up to date.
2. Attempt to reprogram the ECU.
   • If the programming is not successful 
   1. Ignition OFF for 1 minute, ignition ON.
   2. Attempt to reprogram the ECU.
      • If the programming is not successful - Replace the component: K190 Power Line Communication Module
      • Go to next step: If the programming is successful
   3. All OK.
   • Go to next step: If the programming is successful 
3. All OK.