Replace and Program Control Module or Reprogram Control Module
WARNING: This page is about a different car, the 2020 Chevrolet Bolt EV. However, it is still accessible from the selected car via links, so may be relevant.
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- With the Power Steering Assist Motor replaced and reconnected, on the SPS Supported Controllers screen, select K43 Power Steering Control Module - Programming and follow the on-screen instructions.
- Ignition OFF and all vehicle systems OFF. It may take up to 2 minutes for all vehicle systems to power down.
- Ignition ON.
- On the SPS Supported Controllers screen, select K43 Power Steering Control Module - Setup and follow the on-screen instructions.
- Clear DTCs.