LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2021 >> Bolt EV Premier >> Repair and Diagnosis >> General Information >> Reset Procedures >> Programming And Setup >> Repair Instructions >> K190 Power Line Communication Module: Programming and Setup >> Programming an Existing or New Control Module
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Programming an Existing or New Control Module

CAUTION:

DO NOT program the power line communication module with the drive motor battery charger cable connected to the vehicle. Charging the drive motor battery while programming may result in damage to the DC charging contactors.

To program an existing or new control module, perform the following procedure:

  1. Install the special tool: <sptool><sptool-no>EL-49642</sptool-no><sptool-desc>SPS Programming Support Tool</sptool-desc></sptool>
  2. Access the Service Programming System (SPS) and follow the on-screen instructions.
  3. On the SPS Supported Controllers screen, select K190 Power Line Communication Module - Programming and follow the on-screen instructions.
  4. At the end of programming, choose the Clear All DTCs function on the SPS screen.
scientia non olet · About LEMON Manuals