Programming an Existing or New Control Module

To program an existing or new control module, perform the following procedure:

1. Install the special tool: <sptool><sptool-no>EL-49642</sptool-no><sptool-desc>SPS Programming Support Tool</sptool-desc></sptool>
2. Access the Service Programming System (SPS) and follow the on-screen instructions.
3. On the SPS Supported Controllers screen, select K20 Engine Control Module Programming and follow the on-screen instructions.
4. Perform SPS function Immobilizer Learn and follow the on-screen instructions. Refer to Immobilizer System Component Programming .