Replace and Program ECU or Reprogram ECU

NOTE:

When programming the B218R Side Object Sensor Module - Right, it is also necessary to program the B218L Side Object Sensor Module - Left to ensure software compatibility between the two modules.

To program a replacement or an existing ECU, perform the following procedure:

Access the Service Programming System (SPS) and follow the on-screen instructions.
On the SPS Supported Controllers screen, select B218R Side Object Sensor Module - Right.
On the SPS Select Function / Sequence screen, select Programming
On the SPS Supported Controllers screen, select B218L Side Object Sensor Module - Left.
On the SPS Select Function / Sequence screen, select Programming
Clear DTCs.