LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2021 >> Tahoe SSV >> Repair and Diagnosis >> General Information >> Reset Procedures >> Programming And Setup >> Repair Instructions >> Serial Data Authentication Configuration >> Serial Data Authentication Configuration
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Serial Data Authentication Configuration

NOTE:

Before attempting to perform the Serial Data Authentication Configuration procedure,

  • Make sure all CAN control modules are connected and communicating.
  • Diagnose the following communication DTCs first: DTC U0073-U007E, U0100-U02FF, U1100-U12FF, U1600-U17FF, U1977, U1978, U2200-U23FF, and U2400-U25FF.

If DTC U1962 is stored only as a history DTC and not retrieved as a current DTC, do not perform the Serial Data Authentication Configuration procedure.

  1. Ignition/Vehicle OFF, keep the key inside the vehicle.
  2. Access the Service Programming System (SPS) and follow the on-screen instructions.
    3. NOTE:

    The Serial Data Authentication Configuration button is located in the following location:

    • To the left side of the SPS Supported Controllers screen in the TIS system.
    • In the lower right corner of the SPS Supported Controllers screen in the Techline Connect system.
  3. On the SPS Supported Controllers screen, select Serial Data Authentication Configuration button and follow the on-screen instructions.
  4. Ignition/Vehicle OFF, all access doors closed, all vehicle systems OFF, and all keys at least 3 m (9.8 ft) away from vehicle. Disconnect the scan tool from the vehicle. It may take up to 10 min for all vehicle systems to power down.
  5. Ignition ON/Vehicle In Service Mode.
  6. Using a scan tool, clear DTCs.
scientia non olet · About LEMON Manuals