Installation Procedure

Install the power steering control module wiring power harness.
Courtesy of GENERAL MOTORS COMPANY

Install the power steering control module wiring power harness clip (2) to the electric belt drive rack and pinion steering gear housing.
Connect the power steering control module wiring power harness (1) to the power steering assist motor.
Courtesy of GENERAL MOTORS COMPANY

Connect the power steering control module wiring power harness (2) to the main power steering wiring harness (1).
Courtesy of GENERAL MOTORS COMPANY

Install the power steering assist motor wire clip (3).
Position the power steering control module wiring power harness (1) into the 2 retaining clips (2).
Courtesy of GENERAL MOTORS COMPANY

NOTE:
The proper position of the underbody skid shield is between the underbody splash shield and the front frame.

Underbody Skid Shield (3) - Install

CAUTION:

Underbody Splash Shield Bolt (2) - Install and tighten [2x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Underbody Splash Shield (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Underbody Skid Shield Bolt (2) - Install and tighten [4x] - Fastener Specifications
Front Bumper Fascia Skid Plate Bolt (1) - Install and tighten [4x] - Fastener Specifications
Remove the supports and lower the vehicle.
Connect the battery negative cable. Battery Negative Cable Disconnection and Connection (9C1, 5W4) , or Battery Negative Cable Disconnection and Connection (KL9)
Clear DTCs.