Circuit/System Verification
- Ignition - On / Vehicle - In Service Mode
- Operate the component: S126 Ride Control Switch - Rotate Left & Rotate Right
Verify the following information is correctly displayed: Drive Mode @ P9 Driver Information Center Display
- If the component does not work as specified
Refer to: Circuit/System Testing - Test 1
- Go to next step: If the component works as specified
- If the component does not work as specified
- Operate the component: S126 Ride Control Switch - Rotate Left & Rotate Right
Verify the following information is correctly displayed: Drive Mode - LED (Light Emitting Diode) @ S126 Ride Control Switch
- If the component does not work as specified
Refer to: Circuit/System Testing - Test 2
- Go to next step: If the component works as specified
- If the component does not work as specified
- All OK.