LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2021 >> Traverse L >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Vehicle Access System >> Diagnostic Information and Procedures >> DTC B384A >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

    NOTE:

    It may take up to 2 min for all vehicle systems to power down before an accurate ground or low reference circuit continuity test can be performed.

  1. Ignition/Vehicle & All vehicle systems - Off
  2. Disconnect the electrical connector: B70 Liftgate Close Switch
  3. Test for less than 10 ohms between the test points: Low Reference circuit terminal 1 & Ground
    • If 10 ohms or greater 
    1. Disconnect the electrical connector: K39 Liftgate Control Module
    2. Test for less than 2 ohms between the test points: Low Reference circuit terminal 1 @ Component harness & Terminal 16 X1 @ Control module harness
      • If 2 ohms or greater - Repair the open/high resistance in the circuit.
      • If less than 2 ohms - Replace the component: K39 Liftgate Control Module
    • Go to next step: If less than 10 ohms 
  4. Verify a test lamp turns On between the test points: Control circuit terminal 2 & Low Reference circuit terminal 1
    • If the test lamp does not turn On 
    1. Ignition/Vehicle - Off & Remove - Test lamp
    2. Disconnect the electrical connector: K39 Liftgate Control Module
    3. Test for infinite resistance between the test points: Control circuit terminal 2 @ Component harness & Ground
      • If less than infinite resistance - Repair the short to ground on the circuit.
      • Go to next step: If infinite resistance
    4. Test for less than 2 ohms between the test points: Control circuit terminal 2 @ Component harness & Terminal 13 X1 @ Control module harness
      • If 2 ohms or greater - Repair the open/high resistance in the circuit.
      • If less than 2 ohms - Replace the component: K39 Liftgate Control Module
    • Go to next step: If the test lamp turns On 
  5. Ignition/Vehicle - Off
  6. Connect the electrical connector: B70 Liftgate Close Switch
  7. Disconnect the electrical connector: K39 Liftgate Control Module
  8. Ignition - On / Vehicle - In Service Mode
  9. Test for less than 1 V between the test points: Control circuit terminal 13 & Ground
    • If 1 V or greater 
    1. Disconnect the electrical connector: B70 Liftgate Close Switch
    2. Test for less than 1 V between the test points: Control circuit terminal <p01> @ Control module harness & Ground
      • If 1 V or greater - Repair the short to voltage on the circuit.
      • If less than 1 V - Replace the component: B70 Liftgate Close Switch
    • Go to next step: If less than 1 V 
  10. Test or replace the component: K39 Liftgate Control Module
scientia non olet · About LEMON Manuals