Component Testing

S13 Door Lock Switch - Test

Ignition/Vehicle - Off
Disconnect the appropriate electrical connector: S13 Door Lock Switch
Test for infinite resistance between the test points:
- Signal terminal 2 & Ground terminal 4 - Lock Switch - Not Pressed
- Signal terminal 3 & Ground terminal 4 - Unlock Switch - Not Pressed
- If less than infinite resistance
  Replace the component: S13 Door Lock Switch
- Go to next step: If infinite resistance
Test for less than 3 ohms between the test points: Signal terminal 2 & Ground terminal 4 - Lock Switch - Pressed
- If 3 ohms or greater
  Replace the component: S13 Door Lock Switch
- Go to next step: If less than 3 ohms
Test for less than 3 ohms between the test points: Signal terminal 3 & Ground terminal 4 - Unlock Switch - Pressed
- If 3 ohms or greater
  Replace the component: S13 Door Lock Switch
- Go to next step: If less than 3 ohms
All OK.

A23 Door Latch Assembly

Ignition/Vehicle - Off
Disconnect the appropriate electrical connector:
- A23D Door Latch Assembly - Driver
- A23P Door Latch Assembly - Passenger
- A23LR Door Latch Assembly - Left Rear
- A23RR Door Latch Assembly - Right Rear
Connect a 25 A fused jumper wire between the test points: Control terminal 8 & B+

CAUTION:

Complete the testing as quickly as possible in order to prevent overheating and damaging the component.

Momentarily connect a jumper wire between the test points:
- A23D Door Latch Assembly - Driver: Control terminal 7 & Ground
- A23P Door Latch Assembly - Passenger: Control terminal 9 & Ground
- A23LR Door Latch Assembly - Left Rear: Control terminal 7 & Ground
- A23RR Door Latch Assembly - Right Rear: Control terminal 9 & Ground
Reverse the jumper wires 2 times between the terminals.
Verify the component works as specified: A23 Door Latch Assembly = Lock & Unlock
- If not the specified state
  Replace the component: A23 Door Latch Assembly
- Go to next step: If the specified state
All OK.