SIR/SRS Wire Repair

CAUTION:

Do not install more than 2 DuraSeal splice sleeves per SIR deployment loop. A deployment loop consists of both wires from the K36 Inflatable Restraint Sensing and Diagnostic Module to the deployable component. If more than 2 DuraSeal splice sleeves are required for any SIR deployment loop, the complete wire harness must be replaced. More than 2 DuraSeal splice sleeves per deployment loop may increase the resistance in the circuit causing a DTC to be set.

NOTE:

Refer to Wiring Repairs in the service information connector end views or the vehicle schematics in order to determine the correct wire size for the circuit you are repairing. You must obtain this information in order to ensure circuit integrity.

If any wire except the pigtail is damaged, repair the wire by splicing in a new section of wire of the same gauge size (0.5 mm, 0.8 mm, 1.0 mm etc.). Use the DuraSeal splice sleeves and the appropriate splice sleeve crimping tool. For wiring repair, refer to Special Tools .

For connector position assurance (CPA), refer to Connector Position Assurance Locks .

For terminal position assurance (TPA), refer to Terminal Position Assurance Locks .

For connector position assurance (CPA), refer to Wiring Repairs .