Replace and Program Control Module
WARNING: This page is about a different car, the 2020 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
To program a replacement control module, perform the following procedure:
- Ignition/Vehicle OFF
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, under Select Controller, select K182 Parking Assist Control Module.
- On the SPS Supported Controllers screen, under Select Function / Sequence, select Programming and follow on screen instructions.
- On the SPS Supported Controllers screen, under Select Function / Sequence, select Configuration and follow the on-screen instructions.
- Clear DTCs.