LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2021 >> Traverse L >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Programming And Setup) >> Repair Instructions >> K69 Transfer Case Control Module: Programming and Setup >> Unsuccessful Programming Recovery
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Unsuccessful Programming Recovery

WARNING: This page is about a different car, the 2020 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.

If programming a control module is not successful, perform the following procedure:

  1. Verify the control module, data link connector and programming tool connections are secure and the tool software is up to date.
  2. Perform the SPS function:K69 Transfer Case Control Module - Programming

    Verify the control module programming is successful.

    • If the programming is not successful 
    1. Disconnect the battery.
    2. Wait 60 s before proceeding to the next step.
    3. Connect the battery.
    4. Perform the SPS function:K69 Transfer Case Control Module - Programming
      • If the programming is not successful - Replace the component:K69 Transfer Case Control Module
      • Go to next step: If the programming is successful
    5. Perform the scan tool configuration/reset function:Transfer Case Clutch Identifier
    6. Clear DTCs.
    7. All OK.
    • Go to next step: If the programming is successful 
  3. Perform the scan tool configuration/reset function:Transfer Case Clutch Identifier
  4. Clear DTCs.
  5. All OK.
scientia non olet · About LEMON Manuals