LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2021 >> Traverse L >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Programming And Setup) >> Repair Instructions >> P16 Instrument Panel Cluster Control Module: Programming and Setup >> Reprogram ECU (UDV or UHS)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Reprogram ECU (UDV or UHS)

WARNING: This page is about a different car, the 2020 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.

To program a replacement or an existing ECU, perform the following procedure:

  1. Ignition ON/Vehicle in Service Mode.
    2. NOTE:

    Ensure programming of this module is performed using the EL-52100 (MDI 2). Using the EL-47955 (MDI) will result in a programming failure.

  2. Access the Service Programming System (SPS) and follow the on-screen instructions.
  3. Ignition/Vehicle OFF.
  4. On the SPS Supported Controllers screen, select P16 Instrument Cluster - Graphics Programming and follow the on-screen instructions.
  5. On the SPS Supported Controllers screen, select P16 Instrument Cluster - Programming and follow the on-screen instructions.
    6. NOTE:

    If Ethernet programming fails, ensure Instrument Cluster is communicating over ethernet properly. Refer to Scan Tool Does Not Communicate with Vehicle

  7. Clear DTCs.
scientia non olet · About LEMON Manuals