Garage Height Calibration
If any portion of the power liftgate assembly is replaced, repaired or disassembled, perform the following liftgate relearn procedure:
- Ensure that the rotary switch on the overhead console or driver door panel is set to 3/4.
- Press the liftgate handle switch and allow the liftgate to power open.
- Stop movement at the desired height by pressing any operation switch.
- If required, manually move the stopped liftgate to the desired position.
- Press and hold the liftgate close switch for at least 3 seconds. The tail lights will flash if the setting has been successfully programmed.
- Close the liftgate completely using one of the following switches:
- The rotary switch on the overhead console or driver door panel
- The liftgate close switch on the liftgate
- The remote control switch on the keyless entry transmitter
NOTE:
The opening height of the liftgate should be positioned approximately parallel with the roof, the liftgate control module will reject the setting if the liftgate is positioned too low.