Circuit/System Testing
- Ignition OFF and all vehicle systems OFF, disconnect the harness connector at the K17 Electronic Brake Control Module, ignition ON.
- Test for less than 1 V between the K17 Electronic Brake Control Module harness connector terminals listed below and ground:
- B5LF Wheel Speed Sensor - Left Front - terminal 5
- B5LR Wheel Speed Sensor - Left Rear - terminal 16
- B5RF Wheel Speed Sensor - Right Front - terminal 11
- B5RR Wheel Speed Sensor - Right Rear - terminal 29
- If 1 V or greater
Repair the short to voltage on the circuit.
- Go to next step: If less than 1 V
- All OK.