LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2021 >> Traverse LS, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Programming And Setup) >> Repair Instructions >> K9 Body Control Module: Programming and Setup >> Reprogram Control Module
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Reprogram Control Module

WARNING: This page is about a different car, the 2020 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.

To program an existing K9 Body Control Module, perform the following procedure:

    NOTE:

    Begin with the vehicle in vehicle OFF power mode. The Service Programming System will power mode the vehicle.

  1. Ignition/Vehicle OFF.
  2. Access the Service Programming System (SPS) and follow the on-screen instructions.
  3. On the SPS Supported Controllers screen, select K9 Body Control Module - Programming and follow the on-screen instructions.
    4. NOTE:

    When performing the Tire Pressure Monitor Sensor Learn during K9 Body Control Module setup, the EL-52545  Tire Pressure Monitor Sensor and RF Diagnostic Tool must be used to activate each tire pressure sensor for vehicles with UJM.

  4. On the SPS Supported Controllers screen, select K9 Body Control Module - Setup and follow the on-screen instructions.
  5. Check the driver information center display for additional messages regarding further calibration instructions. If there are no additional driver information center instructions present, programming is complete.
  6. Clear DTCs.
scientia non olet · About LEMON Manuals