LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2021 >> Traverse LT, 4WD >> Repair and Diagnosis >> General Information >> Reset Procedures >> Programming And Setup >> Repair Instructions >> K60 Steering Column Lock Module: Programming and Setup >> Replace and Program Column Lock Control Module
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Replace and Program Column Lock Control Module

To program a replacement column lock control module, perform the following procedure:

NOTE:

Before reprogramming, to ensure that the column lock password from the BCM is learned: turn ignition ON and then OFF, close all doors, and wait 5 minutes.

  1. Ignition ON.
  2. Access the Service Programming System (SPS) and follow the on-screen instructions.
  3. If available, on the SPS Supported Controllers screen, select K60 Column Lock Control Module - Prepare Control Module For Removal and follow the on-screen instructions.
    NOTE:

    The Prepare Control Module for Removal function can only be performed when communication with the old control module is still possible

  4. Replace the Column Lock Module. Refer to Control Module References 
  5. Ignition ON for 10 seconds, ignition OFF.
  6. Close all doors and wait 5 minutes.
  7. Ignition ON.
  8. On the SPS Supported Controllers screen, select K60 Column Lock Control Module - Programming and follow the on-screen instructions.
  9. Clear DTCs.
scientia non olet · About LEMON Manuals