LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2021 >> Traverse LT, 4WD >> Repair and Diagnosis >> General Information >> Reset Procedures >> Programming And Setup >> Repair Instructions >> K60 Steering Column Lock Module: Programming and Setup >> Reprogram Column Lock Control Module
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Reprogram Column Lock Control Module

NOTE:

Before reprogramming, to ensure that the steering column lock password from the BCM is learned: turn ignition ON and then OFF, close all doors, and wait 5 minutes.

To reprogram an existing column lock control module, perform the following procedure:

  1. Ignition ON for 10 seconds, ignition OFF.
  2. Close all doors and wait 5 minutes.
  3. Ignition ON.
  4. Access the Service Programming System (SPS) and follow the on-screen instructions.
  5. On the SPS Supported Controllers screen, select K60 Column Lock Control Module - Programming and follow the on-screen instructions.
  6. Clear DTCs.
scientia non olet · About LEMON Manuals