Reprogram Control Module

To reprogram an existing K20 Engine Control Module, perform the following procedure:

1. Access the Service Programming System (SPS) and follow the on-screen instructions.
2. Perform one of the following SPS Programming functions:
   NOTE:

   If both controller options below are listed, select K20/K71 Engine and Transmission Control Modules.

   • K20/K71 Engine and Transmission Control Modules and follow the on-screen instructions.
   • K20 Engine Control Module and follow on-screen instructions.
3. Clear DTCs after completing the Programming procedure.
NOTE:

If vehicle fails to start during Configuration and Setup, perform the SPS Function Immobilizer Learn and follow the on-screen instructions.

4. Perform the following SPS function:
   1. Setup
      NOTE:

      If both controller options below are listed, select K20 Engine Control Module.

      • K20/K71 Engine and Transmission Control Modules and follow the on-screen instructions.
      • K20 Engine Control Module and follow on-screen instructions.
   2. Configuration - If applicable
NOTE:

Resetting of the engine air filter life using the Engine Air Filter Monitor Setup function in the scan tool may be required if it was not transferred during the prepare control module for removal process. Refer to: GM Air Filter Life System Resetting

6. If equipped, perform the Fuel Pressure Regulator Learn via GDS2, Engine Control Module, Configuration/Reset Functions, Learn Functions.
7. Clear DTCs.