Replace and Program Control Module With New Rear Differential Assembly

To program a replacement control module, perform the following procedure:

1. Install the new rear differential assembly with new K47 Rear Differential Clutch Control Module.
2. Access the Service Programming System (SPS) and follow the on-screen instructions.
3. On the SPS Supported Controllers screen, select K47 Rear Differential Clutch Control Module - Prepare the Control Module for Removal and follow the on-screen instructions.
4. Replace the new K47 Rear Differential Clutch Control Module with the original K47 Rear Differential Clutch Control Module.
5. On the SPS Supported Controllers screen, select K47 Rear Differential Clutch Control Module - Programming and follow the on-screen instructions.
6. On the SPS Supported Controllers screen, select K47 Rear Differential Clutch Control Module - Setup and follow the on-screen instructions.
   NOTE:

   RPO F48 or G99 = Twin Clutch System

7. Clear DTCs.