LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2024 >> Traverse LS, FWD >> Repair and Diagnosis >> General Information >> Reset Procedures >> Programming And Setup >> Repair Instructions >> K73 Telematics Communication Interface Control Module: Programming and Setup (UE1) >> Programming Control Module for an Update
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Programming Control Module for an Update

To program an existing control module for an update, perform the following procedure:

NOTE:

Begin with the vehicle in the vehicle OFF power mode. The Service Programming System will power mode the vehicle.

  1. Ignition / Vehicle OFF.
  2. Access the Service Programming System (SPS) and follow the on-screen instructions.
  3. Check and follow Preliminary Information or Technical Service Bulletins before programming. If control module software updates are available, in the SPS Supported Controllers screen, select K73 - Software Update and follow the on-screen instructions.
    NOTE:

    For programming an existing module, you only need to perform "Software Update".

  4. Clear DTCs.
scientia non olet · About LEMON Manuals