Adding NFC Cards
To add Key Cards, perform the following procedure:
NOTE:
- The vehicle is capable of learning a total of 8 key cards.
- Connect a scan tool to the vehicle and access SPS.
- Select the SPS application and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select K183 UHF Short Range Low Energy Remote Control Access Transceiver.
- Select Key Card Learn.
- Select the Add Card function.
- Refer to the owners manual or the key card for key card reader location.
- Follow the on-screen instructions.
- With a scan tool, clear any DTCs.
- Verify each card that was programmed is operating properly. Ensure the card locks or unlocks the vehicle.
NOTE: