Programming a New Control Module
NOTE:
Instances may occur where data is not transferred during the Prepare Control Module for Removal Function
- Ignition - On/Vehicle - In Service Mode
- Perform the scan tool function: Create Report
- Air Cleaner Life Remaining
- Engine Oil Life Remaining
- Fuel Filter Life Remaining
- Injector Flow Identifier
- Prepare the component for replacement.
Select: Prepare Control Module for Reprogramming or Removal - If applicable
- Ignition/Vehicle - Off
- Replace the component: K45 Powertrain Control Module
- Ignition - On/Vehicle - In Service Mode
- If equipped, perform the SPS function Immobilizer Learn and follow the on-screen instructions. Refer to Immobilizer System Component Programming .
- Access SPS and follow the on-screen instructions for the control module: K45 Powertrain Control Module
- Perform the necessary programming and setup procedure:
- Select: Refresh Characterization Data
- Select: Replace - Control Valve Body
- Select: Replace - Transmission
- Perform the scan tool function: Clear DTCs
- Perform the scan tool configuration/reset function:
- Configuration/Reset Functions - Engine - If applicable
- Configuration/Reset Functions - Transmission - If applicable
- Perform the scan tool function: Clear DTCs
NOTE:
The Prepare Control Module for Removal function can only be performed when communication with the old control module is still possible.