Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

Luggage Shade (1) - Remove

1. Open the liftgate.
2. Release the luggage shade straps from the luggage shade pivot on both sides.

Courtesy of GENERAL MOTORS COMPANY

Load Floor Stowage Compartment Cover (1) - Remove

Courtesy of GENERAL MOTORS COMPANY

Grasp and gently pull up on the liftgate sill garnish molding (1) in order to release the integral retaining clips.

Courtesy of GENERAL MOTORS COMPANY

Cargo Tie Down Loop Fastener - Right Side (1) - Remove

Courtesy of GENERAL MOTORS COMPANY

Rear Compartment Courtesy Lamp (1) - Remove

Courtesy of GENERAL MOTORS COMPANY

Use a flat-bladed tool to open the quarter window trim finish panel bolt cap.

1. Use a flat bladed plastic trim tool.
2. Grasp and gently pull up on the body lock pillar upper trim panel.

Courtesy of GENERAL MOTORS COMPANY

Rear Seat Back Cushion (1) - Remove - Rear Seat Back Cushion Removal and Installation (60 Percent Seat) - 60%

Courtesy of GENERAL MOTORS COMPANY

Rear Side Door Sill Garnish Molding (1) - Remove

1. Starting at the front of the sill garnish molding, pull upward at the B-Pillar joint to disengage sill garnish molding.
2. Work your way rearward disengaging all of the garnish molding clips then pull forward to disengage from the C-Pillar lower.
3. Replace the retainers as required.

Courtesy of GENERAL MOTORS COMPANY

Rear Seat Belt Retractor Bolt (1) - Remove

Courtesy of GENERAL MOTORS COMPANY

Quarter Lower Rear Trim Panel (1) - Remove

1. Release the retainers with a suitable plastic trim tool.
2. Grasp and gently pull up on the quarter lower rear trim panel.
3. Pull the rear seat belt through the quarter lower rear trim panel.

Courtesy of GENERAL MOTORS COMPANY

Disconnect the electrical connectors.