Removal Procedure

Open the liftgate.
Courtesy of GENERAL MOTORS COMPANY

Load Floor Mat (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Load Floor Stowage Compartment Cover (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Grasp and gently pull up on the liftgate sill garnish molding (1) in order to release the integral retaining clips.
Liftgate Sill Garnish Molding (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Both sides shown. The quantity is for the one side.

Cargo Tie Down Loop Fastener - Right Side (1) - Remove
Cargo Tie Down Loop - Right Side (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Rear Compartment Courtesy Lamp - Right Side (1) - Remove
Disconnect the electrical connector.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Use a flat-bladed tool to open the quarter window trim finish panel bolt cap.
Quarter Window Trim Finish Panel Bolt - Right Side (1) - Remove
Body Lock Pillar Upper Trim Panel - Right Side (2) - Remove
1. Use a flat bladed plastic trim tool.
2. Grasp and gently pull up on the body lock pillar upper trim panel.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Rear Compartment Panel Bolt - Right Side (1) - Remove [2x]
Cargo Partition Rail Bracket - Right Side (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Rear Compartment Panel Bolt - Right Side (1) - Remove [2x]
Rear Compartment Panel Reinforcement - Right Side (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Load Floor Rear Compartment Cover (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Cargo Tie Down Loop Fastener (1) - Remove [2x]
Cargo Tie Down Loop (2) - Remove [2x]
Courtesy of GENERAL MOTORS COMPANY

Rear Compartment Floor Stowage Compartment Bracket Bolt (1) - Remove [6x]
Load Floor Trim Panel (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Rear Side Door Sill Garnish Molding - Right Side (1) - Remove
1. Starting at the front of the sill garnish molding, pull upward at the B-Pillar joint to disengage sill garnish molding.
2. Work your way rearward disengaging all of the garnish molding clips then pull forward to disengage from the C-Pillar lower.
3. Replace the retainers as required.
Courtesy of GENERAL MOTORS COMPANY

Quarter Lower Rear Trim Panel (1) - Remove
1. Release the retainers with a suitable plastic trim tool.
2. Grasp and gently pull up on the quarter lower rear trim panel.
Transfer components as necessary.
Courtesy of GENERAL MOTORS COMPANY

Disconnect the electrical connectors.
Remote Function Actuator Module (1) - Remove