Ignition System - V8: Overhaul: Disassembly
- Remove distributor cap. Using 2 screwdrivers, pry off rotor from shaft. Remove reluctor by prying up from bottom of reluctor using 2 pry bars or screwdrivers with a maximum width of 7/16". Be careful not to distort or damage reluctor teeth.
- Remove 2 screws and lock washers attaching plate to housing, and lift out plate and pick-up coil(s) as an assembly. DO NOT attempt to remove distributor cap clamps, as they are peened in place.
- If distributor has more than .006" (.15 mm) shaft side play, replace housing shaft and reluctor sleeve by removing shaft retaining pin and sliding retainer off end of shaft.