Displaying Fault Codes
- Attach Diagnostic Readout Box (C-4805) to diagnostic connector, which is located near right front strut tower. Set read/hold switch in "READ" position. If diagnostic readout box is not available, flashing of power loss lamp may be used to read fault codes.
- If possible, start engine. Move A/T selector lever through all positions, ending in Park. If equipped, turn A/C on, then off. Turn engine off. DO NOT restart engine. Turn ignition on, off, on, off and on, completing sequence in 5 seconds. Record all fault codes as displayed by diagnostic readout box.
- If using power loss lamp for display, use same sequence to initiate display. Power loss lamp will first light up for 2 seconds to check bulb. After bulb check, power loss lamp will display fault codes by series of flashes.
- There are short pauses between flashes and longer pauses between digits, with 4 second pause between codes. For example, fault code 23 would be displayed by flash, flash, pause, flash, flash, flash. After 4 second pause, next numerically higher fault code will be displayed.
- Note that display of specific fault code denotes probable area of malfunction. Although code is set as result of specific failure in system, specific component involved is NOT identified by fault code. Following list presents fault codes and system malfunctions which they represent.