LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 1992 >> Imperial >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - Body Control Computer >> Self-Diagnostic Tests >> Test 47 - Key In Ignition >> TEST 47B - Key In Ignition
April 5, 2026: LEMON Manuals is launched! Read the announcement.

TEST 47B - Key In Ignition

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION . For wiring diagrams, see appropriate chassis wiring diagram in the WIRING DIAGRAMS Section.
  1. Ensure driver's door is open. Remove key from ignition switch. If DRB-II displays CIRCUIT OPEN, perform TEST 42A. If DRB-II does not display CIRCUIT OPEN, disconnect key-in-ignition connector. See Figure. Check connector condition, and clean or repair connector as necessary.
  2. If DRB-II does not display CIRCUIT CLOSED, replace key in ignition switch. Perform VERIFICATION TEST VER-1 . If DRB-II displays CIRCUIT CLOSED, disconnect body controller Black connector. Body controller is located behind right side kick panel. Check connector condition, and clean or repair connector as necessary. Put DRB-II in ohmmeter mode.
  3. Probe terminal No. 2 (Light Blue wire) of body controller Black connector. If resistance is less than 5 ohms, repair short to ground in Light Blue wire. Perform VERIFICATION TEST VER-1 . If resistance is more than 5 ohms, replace body controller. Perform VERIFICATION TEST VER-1 .
scientia non olet · About LEMON Manuals