Test 15B - Electronic Instrument Cluster Display Blank
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION
. For appropriate wiring diagram, see WIRING DIAGRAMS
at end of article.
Turn ignition off. Disconnect electronic instrument cluster 13-pin connector from back of cluster. Using DRB-II in ohmmeter mode, check resistance on terminal No. 7 (Black/Light Green wire) of electronic instrument cluster 13-pin connector. If resistance is more than 5 ohms, repair open Black/Light Green wire. Perform VERIFICATION PROCEDURE VER-1. If resistance is less than 5 ohms, replace electronic instrument cluster. Perform VERIFICATION PROCEDURE VER-1.