Test 3C - Automatic Door Locks With Remote Keyless Entry
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION
. For wiring diagrams, see WIRING DIAGRAMS
at the end of this article.
- Using DRB-II, stop door lock actuation test. Turn ignition off. Gain access to power door lock relays. Relays are located behind right side of glove box. See Figure . Remove door unlock relay. Check connector condition, and clean or repair connector as necessary.
- Put DRB-II in ohmmeter mode and check resistance of Black wire of door unlock relay connector. If resistance is more than 5 ohms, repair open Black wire. Perform VERIFICATION PROCEDURE VER-1. If resistance is less than 5 ohms, check resistance of Pink/Black wire of unlock relay connector.
- If resistance is more than 5 ohms, repair open Pink/Black wire. Perform VERIFICATION PROCEDURE VER-1. If resistance is less than 5 ohms, replace door unlock relay. Perform VERIFICATION PROCEDURE VER-1.