Test 3D - Automatic Door Locks With Remote Keyless Entry
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION
. For wiring diagrams, see WIRING DIAGRAMS
at the end of this article.
- Ensure DRB-II door lock actuation test is still active. Disconnect remote keyless entry module. See Figure . Check connector condition, and clean or repair connector as necessary. Check voltage on terminal No. 3 (Dark Blue wire) of remote keyless entry module Black connector.
- If voltage pulsates between zero and 12 volts, replace remote keyless entry module. Perform VERIFICATION PROCEDURE VER-1. If voltage does not pulse between zero and 12 volts, check wiring and door lock motor. Repair as necessary. Perform VERIFICATION PROCEDURE VER-1.