Test 61A - Headlight Doors Do Not Operate By Headlight Switch

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION . For appropriate wiring diagram, see WIRING DIAGRAMS at end of article.

Using DRB-II, stop headlight door test. Put multifunction control lever in low beam position. Put DRB-II in voltmeter mode. Turn ignition off. Disconnect Body Control Module (BCM) Red connector. BCM is located behind right side kick panel.
Check connector condition, and clean or repair connector as necessary. Check voltage on terminal No. 9 (Violet/White wire) of BCM Red connector. If voltage is more than 10 volts, replace BCM. Perform VERIFICATION PROCEDURE VER-1. If voltage is less than 10 ohms, repair open Violet/White wire. Perform VERIFICATION PROCEDURE VER-1.