Test 62A - Headlight Doors Will Not Open
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION
. For appropriate wiring diagram, see WIRING DIAGRAMS
at end of article.
- Turn headlight switch off. Turn ignition off. Disconnect headlight door motor connector. Connector is located behind center of front grill. Check resistance of Brown/Orange wire terminal of headlight door motor connector. If resistance is more than 5 ohms, go to step 4).
- If resistance is less than 5 ohms, use an external ohmmeter to check resistance between Dark Blue/Orange wire terminal of headlight door motor connector and Dark Blue/Yellow wire terminal of headlight door open relay connector.
- If resistance is more than 5 ohms, repair open Dark Blue/Orange wire or Dark Blue/Yellow wire. Perform VERIFICATION PROCEDURE VER-1. If resistance is less than 5 ohms, replace headlight door motor. Perform VERIFICATION PROCEDURE VER-1.
- Disconnect headlight door close relay. Using an external ohmmeter, check resistance between Brown/Orange wire terminal of headlight door motor connector and Brown/Yellow wire terminal of headlight door open relay connector.
- If resistance is more than 5 ohms, repair open Brown/Orange wire or Brown/Yellow wire. Perform VERIFICATION PROCEDURE VER-1.
- If resistance is less than 5 ohms, put DRB-II in ohmmeter mode. Check resistance on terminal "E" (Black wire) of headlight door close relay connector. If resistance is less than 5 ohms, replace headlight door close relay. Perform VERIFICATION PROCEDURE VER-1. If resistance is more than 5 ohms, repair open Black (ground) wire. Perform VERIFICATION PROCEDURE VER-1.