Test 8D - Short To 5 Volts
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION
. For appropriate wiring diagram, see WIRING DIAGRAMS
at end of article.
CAUTION:
Always turn ignition switch to OFF position before disconnecting or connecting any module connector.
- Using DRB-II in ohmmeter mode, check traveler ground wire. On AG and AJ bodies, check resistance between traveler connector CCD bus negative circuit (White/Black wire) and traveler connector traveler ground circuit (Dark Green wire). If resistance is more than 5 ohms, repair open circuit in Dark Green wire. Perform VERIFICATION PROCEDURE VER-1.
- On AA body, check resistance between visual message center connector traveler ground circuit (Black wire) and traveler connector CCD bus negative circuit (White/Black wire).
- If resistance is more than 5 ohms, repair open circuit in Black wire. Perform VERIFICATION PROCEDURE VER-1. If resistance is less than 5 ohms, replace traveler module. Perform VERIFICATION PROCEDURE VER-1.