Test 95A - Identifying Power Door Lock & Remote Keyless Entry Problem

NOTE: Perform TEST 87A or 95A before proceeding with this test. For connector terminal ID, see CONNECTOR IDENTIFICATION and WIRING DIAGRAMS . Drive vehicle to update OTIS and perform TEST VER-1 - VERIFICATION PROCEDURE after each repair.

Lower both front windows. Remove key from ignition switch. Close all doors. Lock and unlock doors from both front door switches. If doors fail to lock or unlock properly, perform appropriate test listed in TEST 95A DIAGNOSTIC DIRECTORY table. If doors lock and unlock properly, go to next step.

TEST 95A DIAGNOSTIC DIRECTORY

Problem

Perform

All Doors Fail To Lock & Unlock From Any Switch

TEST 88A

All Locks Fail To Operate Correctly, Trunk May Open Or Fail To Close On Lock Command

TEST 102B

One Door ⁽¹⁾ Fails To Lock & Unlock From Any Switch

TEST 89A

All Doors Fail To Lock & Unlock From One Switch

TEST 90A

All Doors Fail To Lock From Any Switch

TEST 91A

All Doors Fail To Lock From One Switch

⁽²⁾

All Doors Fail To Unlock From Any Switch

TEST 92A

All Doors Fail To Unlock From One Switch

⁽²⁾

Left Front Door Fails To Lock & Unlock From Any Switch

TEST 96A

Left Front Door Fails To Lock From Any Switch

TEST 97A

Left Front Door Fails To Unlock From Any Switch

TEST 98A

All Doors ⁽¹⁾ Fail To Lock & Unlock

TEST 99A

All Doors ⁽¹⁾ Fail To Lock

TEST 100A

All Doors ⁽¹⁾ Fail To Unlock

TEST 101A

⁽¹⁾	Except left front door.

⁽²⁾	Replace defective switch.

Using Remote Keyless Entry (RKE) transmitter, operate door locks and trunk lock. If door locks and trunk lock do not operate properly, replace transmitter batteries or substitute a known-good transmitter. If RKE transmitter still does not operate properly, go to TEST 102A . If RKE transmitter operates properly, go to next step.
Insert key in ignition switch. Open left front door. Lock doors from either switch. If doors lock with key in ignition switch, go to TEST 93A . If doors do not lock with key in ignition switch, go to next step.
If vehicle is equipped with speed sensitive locks, drive vehicle with all doors closed. Reach a vehicle speed more than 15 MPH. If doors do not lock at more than 15 MPH, go to TEST 94A . If doors lock, system is operating properly at this time.