LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chrysler >> 1994 >> LeBaron GTC >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - Body Control Computer (Convert) >> Self-Diagnostic Tests >> Test 53C - Repairing Traveler Elapsed Time
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test 53C - Repairing Traveler Elapsed Time

NOTE: For connector terminal identification, see CONNECTOR  IDENTIFICATION. For wiring diagram, see WIRING DIAGRAMS  . Perform TEST VER-1 after each repair.
CAUTION: Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.
  1. Disconnect Body Control Module (BCM) Black connector. Check connector condition and clean or repair connector as necessary. Put DRB in voltmeter mode. Measure voltage at BCM Black connector terminal No. 16 (Pink wire). If voltage is less than 10 volts, repair open Pink wire. If voltage is more than 10 volts, go to next step.
  2. Turn ignition switch to ON position. Measure voltage at BCM Black connector terminal No. 12 (Dark Blue/White wire). If voltage is more than 10 volts, replace BCM. If voltage is less than 10 volts, repair open Dark Blue/White wire.
scientia non olet · About LEMON Manuals