Instrument Cluster Test 18A - Fog Light Indicator
NOTE:
Perform INSTRUMENT CLUSTER TEST 4A
before proceeding with this test. For connector terminal identification, see CONNECTOR IDENTIFICATION in BODY CONTROL COMPUTER INTRODUCTION. Perform TEST VER-1A
after each repair.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.
- Turn headlight on low beam. Ensure headlight low beam is operating properly. Turn fog lights on. If headlights and fog lights are not operating properly, repair lights as necessary. If headlights and fog lights are operating properly, go to next step.
- Disconnect instrument cluster. Ensure connectors are clean and not damaged. See Figure in INSTRUMENT CLUSTER TEST 8A. Remove and inspect fog light indicator light bulb. If bulb is okay, go to next step. If bulb is defective, replace fog light indicator light bulb.
- Using scan tool in voltmeter mode, check voltage on instrument cluster Blue 13-pin connector terminal No. 6 (Light Blue/Orange wire). Turn ignition and fog lights on. If voltage is less than 10 volts, repair Light Blue/Orange wire. If voltage is more than 10 volts, repair or replace instrument cluster.