Test 107A - Wiper Motor Intermittent Speed Operation
NOTE:
Perform TEST 103A
before proceeding with this test. For connector terminal ID, see CONNECTOR IDENTIFICATION
. For wiring schematics, see WIRING DIAGRAMS
in this article. Perform TEST VER-1 - VERIFICATION PROCEDURE
after each repair.
CAUTION:
Always turn ignition off prior to disconnecting any module connector.
Turn ignition on. Move wiper switch through all 6 different delay (intermittent speed) levels. Using scan tool, read wiper switch status. If voltage is present at each position, replace BCM. If voltage is not present at each position, replace multifunction switch.