Test 145B - Repairing VTSS Indicator Light
NOTE:
Perform TEST 144A
before proceeding with this test. For connector terminal ID, see CONNECTOR IDENTIFICATION
. For wiring schematics, see WIRING DIAGRAMS
in this article. Perform TEST VER-3A - VERIFICATION PROCEDURE
after each repair.
CAUTION:
Always turn ignition off prior to disconnecting any module connector.
Disconnect Body Control Module (BCM) Black connector. Ensure connector is clean and undamaged. BCM is located behind right kick panel. If VTSS indicator light does not stay on, replace BCM. If VTSS indicator light stays on, repair Black/Orange wire at terminal No. 10 for short to ground.