Test 58B - Instrument Cluster Printed Circuit Board
NOTE:
Perform TEST 58A
before proceeding with this test. For connector terminal ID, see CONNECTOR IDENTIFICATION
. For wiring schematics, see WIRING DIAGRAMS
in this article. Perform TEST VER-1 - VERIFICATION PROCEDURE
after each repair.
CAUTION:
Always turn ignition off prior to disconnecting any module connector.
- Using scan tool, stop actuation test. Turn ignition off. Disconnect instrument cluster. Remove and inspect inoperative lamp. Replace lamp if necessary. If lamp is okay, go to next step.
- Inspect instrument cluster printed circuit board. Replace printed circuit board if necessary. If printed circuit board is okay, repair or replace instrument cluster. See appropriate INSTRUMENT PANEL article in the ACCESSORIES & ELECTRICAL section.